What Are the 4 Types of CAN?
Table of Contents
In the CAN specification, “types of CAN” has a precise meaning. It refers to the four protocol-level CAN frame types, not CAN variants such as CAN FD or high-speed CAN.
Short Answer: What Are the 4 Types of CAN?
The four types of CAN are Data Frame, Remote Frame, Error Frame, and Overload Frame.
These are protocol-level CAN frame types used for data transmission, data requests, error signaling, and bus timing control. They are defined by the CAN specification and are not related to CAN physical-layer variants such as CAN FD or high-speed CAN.
Understanding CAN Frame Types
In a CAN network, all communication happens in the form of frames.
Each frame type serves a different role in ensuring reliable, deterministic, and fault-tolerant communication on the bus.
The CAN protocol defines exactly four frame types, each with a specific purpose:
Data Frame
Remote Frame
Error Frame
Overload Frame
1. Data Frame
The Data Frame is the most commonly used CAN frame and the only one that carries actual application data.
Purpose of the Data Frame
Transmits payload data between CAN nodes
Used by ECUs, controllers, sensors, and actuators
Forms the majority of traffic on a CAN bus
Key Characteristics
Contains a data field (0–8 bytes in Classical CAN)
Uses an identifier for arbitration and priority
Lower identifier value means higher bus priority
In most real-world CAN systems, nearly all meaningful communication occurs through data frames.
2. Remote Frame
A Remote Frame is used to request data from another node on the CAN bus.
Purpose of the Remote Frame
Requests transmission of a specific data frame
Enables request–response communication patterns
Key Characteristics
Does not contain a data field
Uses the same identifier as the requested data frame
Sets the RTR (Remote Transmission Request) bit
Although Remote Frames are less commonly used in modern systems, they remain part of the CAN standard and are supported by compliant controllers.
3. Error Frame
The Error Frame is a critical part of CAN’s built-in fault-handling mechanism.
Purpose of the Error Frame
Signals that a communication error has been detected
Immediately disrupts the current frame transmission
Notifies all nodes on the bus of the error
Why Error Frames Matter
Enable detection of bit, CRC, format, and acknowledgment errors
Support CAN error counters and node state transitions
Form the basis for error-active, error-passive, and bus-off behavior
Without Error Frames, CAN would not achieve its high level of reliability in noisy or harsh environments.
4. Overload Frame
The Overload Frame is the least discussed but still standardized CAN frame type.
Purpose of the Overload Frame
Requests a delay before the next frame transmission
Allows a node additional processing time
Does not indicate an error condition
Key Characteristics
Contains no data
Does not affect error counters
Used to manage bus timing under specific conditions
In modern high-performance CAN controllers, Overload Frames are rare, but they remain part of the protocol definition.
CAN Frame Types vs. CAN Variants
When searching for “types of CAN,” you may also encounter terms such as:
High-speed CAN
Low-speed (fault-tolerant) CAN
Single-wire CAN
CAN FD
It is important to understand that:
These are not CAN frame types.
They describe physical-layer characteristics or data-rate extensions, not protocol-level frames.
The four CAN frame types—Data, Remote, Error, and Overload—exist regardless of the physical layer or CAN variant being used.